Dollfie Dream neck mod

Woot Otacool3 get ^^; Decided to do a dollfie dream mod on Mirin, came across a link on modifying dollfie dream when it was posted by sushi_n_sake on twitter. The link about the mod is for the elbow joint, but I read in one of the comments that it can be done on the neck joint, and decided to try that out :)

Why I wanted to do the mod is mainly because when we try to take photos of the dollfie dream lying on their belly trying to read a book, sometimes their head tend to be bowing too low to catch their faces.

With the mod done there’s a slightly better view of the face when I try to take pictures of this pose.

Below are some pictures of the doll parts, if you feel disturbed please do not continue ^^;

Also if you intend to do the mod, please please think carefully if you decide to do it on a limited bust– example Yoko or Kanu’s dynamite body/bust — It’s a bit hard to come by/replace ^^;

…

..

.

So here’s a view of what I did:

The neck part is rather soft so it was a bit difficult to cut — there’s a potential risk of cutting too much ^^;, so with this little nook I cut out with a pen knife, the point where the head is inserted can now bend backwards a bit more. As you can see since the neck part is soft, the nook is opened up a bit. I’ll have to try to clean up the parts which splits open ^^;

View from the side:

View from the top:

For comparison, Himitsu (closer to us) has not been modded, Mirin (further from us) has been modded. Mirin can definitely tilt her head back a bit more compared to Himitsu.

I put them into similar pose. Please be careful when you try to bend your dollfie dream backwards, do not do it too hard, as there may be a risk of stressing and breaking over time.

view from behind to show that the back arc is similar.

View from the side.

Mirin and Himitsu are chillaxing on my desk now XD

Kawaii ne? ^o^!

Tidied up my desk cos of Otacool3 arrival and was feeling inspired by Danny’s desk diary post XD